Draw panel > Polyline
Pick a point and point down
Enter 500
Command line: Arc
Move cursor to right
Enter 500
Move cursor to right
Enter 500
Command line: Line
Enter 250
Move cursor to right
Enter 1500
Polyline with Width
Start Polyline command
Pick a point and move cursor up
Enter 1000
Command line: Arc
Command line: Width
Specify starting width: 0.00
Press Enter for 0 width
Specify ending width: 300
Move corsor to right, enter 600
Command line: Line
Move cursor down, enter 1000
Arc Direction
Start Polyline command
Pick a point move to right
Command line: Width
Specify starting width: 0
Press Enter for the ending width 0
Pick a point and move cursor up
Enter 1000
Command line: Arc
Move cursor to right
Enter 500
Hold Ctrl key and move cursor to right
Enter 500
Move cursor to right, enter 500
Repeat the same steps for few more arcs
Command line: Line
Move cursor down, enter 1000
Polyline Edit
Double-click on the polyline
Select Close
For another drawing
Draw a line at 750 up
Draw another line to close it
Double-click on the polyline
Select Join
Cross-select lines and polyline
Press Enter
Lines convert to polyline and join into one
Double-click on the polyline again
Select Width
Specify new width for all segments: 100
No comments:
Post a Comment